Hello, I just wanted to say I went and ordered the Volquartsen Custom Ltd. complete (trigger, accurizing, & targer hammer) kit. I installed it today, after being a little apprehensive about doing it because the instructions just seemed to complex and hard to understand but after going to the web site and viewing the process done (about 3 times) I got up the courage to do it. It took about 45 min. and the only fitting I had to do was file the width of the sear down, as it was about .010 wider than the original one, so it would not fit in the frame where the pin went through. Anyway I got it done and every thing seems to work correctly but going to the range soon to try it out. The trigger feels really good after I used the adjusting screws to get it where I wanted it. Thanks for the advice, LM.
PS. the only part of the kit I not sure I like is the slide release as its larger and sticks out like a sore thumb. So anyone know if putting the old slide release would make any differance? It doesn't seem as if it would, but want to know if anyone as done their's that way?