OK guys, might have pulled a stupid move here. Today I bedded the gap in the forestock/ wrist piece area, filling it for no fore-aft movement, the issue came when I bedded the contact area of the entire action and the first six inches of the barrel channel. At first the sear wouldn't engage at all, then I started slowly removing the rear of the action area's bedding compound, pass at a time with a file, assemble, test, repeat. Now I have a single stage trigger with some creep instead of a two stage trigger. the half cock notch wouldn't engage at first, but after judicious removal of compound it will now. I put it on half-cock and cannot get it to disengage by pulling up away from the sear, the same for full cock.
Also now there is a bit more spring pressure when assembling the trigger guard at the king screw area. Recommendations for places to look to adjust fitment?