kmw1954
Member
Folks I just picked up a Boyds Spike Camp stock for my Savage Model 10 and I think I have a fitment issue. Until I replaced the original wood stock the gun was shooting sub-MOA even out to 300yds.
Today I took it out for the first time and am completely discouraged. At 200yds it is not shooting any group at all as a matter of notice the groups seemed to be opening up the more I shot it.
When I mounted it I checked and there was contact on the rear tang to one side. So after about 20 rounds I gave up and brought it home. Have it apart right now and I can see a small mark on the tang area, small mark in the area of the bolt release and a dent in the wood around the front action screw.
Now I have seem videos mention Bedding Black for inletting but is there anything else that I can use to substitute from a local store?
Today I took it out for the first time and am completely discouraged. At 200yds it is not shooting any group at all as a matter of notice the groups seemed to be opening up the more I shot it.
When I mounted it I checked and there was contact on the rear tang to one side. So after about 20 rounds I gave up and brought it home. Have it apart right now and I can see a small mark on the tang area, small mark in the area of the bolt release and a dent in the wood around the front action screw.
Now I have seem videos mention Bedding Black for inletting but is there anything else that I can use to substitute from a local store?