case trimmer

Yes a great trimmer system. I recently made the transition from Lee to the WFT.

I still find that i need to debur/chamfer the case mouths though. I trim all the cases, then dress up the mouths. Process goes quick.

cfullgraf said:

I still find that i need to debur/chamfer the case mouths though. I trim all the cases, then dress up the mouths. Process goes quick.

Click to expand...

Try a higher speed setting.

With that said, I've been following him for about 3 years now, since he was still in development and before he really had a finished product. I've tried quite a few but haven't bought one yet as I haven't had a need to trim cases in a while. It worked great on my drill at the highest speed setting, no need to debur\chamfer, especially after tumbling again.

Thanks. It is not that the cases need chamfer/deburring, but I can feel a little ledge with my finger nail on the outside and I prefer a little chamfer on the inside of the case mouth.

I got this thing against sharp edges on machined parts.

They are about as good as you are gonna get until you step up to a fully dedicated unit like the Giraud, Gracey or Dillon rt. Listed in the order of the best to next best.