Ok guys, looks like the combination of all of your suggestions has gotten me to an operational point. Cleaned the die real well, put back together and fiddled with the adjustment. Put a bit of lube inside neck, and on the case and it went a lot smoother, and no shoulder bend. There was some...
Unboxed and set up rock chucker with 7mm rem mag fl die. Set resizing die up according to instructions, Lubed outside of case and ran a case. Upon upward motion on handle, the case was extremely stuck in the die and the shoulder of the case is dented.
Thoughts?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.