horseman1

Member From Colorado

Joined: Mar 26, 2013

Last seen: Tuesday at 12:20 PM

Latest activity Postings Images About

- H
  
  horseman1 reacted to JRSR's post in the thread Leading Problems with Like.
  
  Thanks for all of the suggestions! I'm going to try gas checks and look for a plain base 240 grain bullet and try it with Titegroup.
  
  Tuesday at 2:34 AM
- H
  
  horseman1 reacted to GeoDudeFlorida's post in the thread Leading Problems with Like.
  
  Have you considered the possibility that this might be related?
  
  Tuesday at 2:32 AM
- H
  
  horseman1 reacted to Jim Watson's post in the thread Calculator for components on hand with Like.
  
  That is what the fine print about “starting loads” and “working up” is for. Given caliber, powder, and bullet weight, but not your...
  
  Tuesday at 2:17 AM
- H
  
  horseman1 reacted to Walkalong's post in the thread First failure with Like.
  
  Correct, on auto cases like the .45 ACP neck tension holds the bullet, the taper "crimp" is only to remove any belling. The rounds...
  
  Tuesday at 2:15 AM
- H
  
  horseman1 reacted to 9mmepiphany's post in the thread First failure with Like.
  
  Please let go of this notion, that you have, that setback is prevented by crimping . Set back is usually controlled by neck tension...
  
  Tuesday at 2:14 AM
- H
  
  horseman1 reacted to Shak3s1977's post in the thread How many have done this before? with Like.
  
  Well I wasn't paying attention when depriming 44 magnum brass tonight. GFL brass and their crooked primer holes. I went to tilt the case...
  
  Tuesday at 1:48 AM
- H
  
  horseman1 replied to the thread American Reloading.
  
  Hi Jim, I've received everything I've ordered from them and was satisfied with their shipping and products. I think the last items I...
  
  May 6, 2024
- H
  
  horseman1 reacted to longdayjake's post in the thread What am I doing wrong? with Like.
  
  Here is what I recommend to customers that have chambering issues. Take a black or blue sharpie marker and paint the entire round with...
  
  May 3, 2024
Show older items
Loading…
Loading…
Loading…

Home
Members