Recent content by 338reddog

I wrote about Randy here in 2019. Same B.S tactics. He is nothing but a liar, so much so he goes to sweat lodge to atone for his sins. His words. Back then I contacted the site his ad was on and after talking to them and giving them the rundown and told him to talk to the game cop in the...

In Stockton Ken Genecco, Genecco Gun works Awesome guy who has helped me a bunch. Paul at Barnwood Arms,Ripon Ca. Has helped me a time or two.

Update to my issue. Sorry its been a while but moving and health issues have put me behind on some project’s. I ended up replacing the extractor spring and decided I would measure the gas port hole on the barrel. It appeared to be undersized. I drilled it out to 5/64 and put it all back...

338 win “A little big for mice, a little small for elephants but just right for everything in between.” Not my quote, it was in a article about the 338 I have killed more deer with this cartridge followed by my favorite the 30/06

Not sure if the bottom of the bolt is dragging the round slightly out of the magazine. My explanation is probably not great as I’m new to this platform. The round maybe moves forward a 1/4” out of the magazine. Will do as suggested. I will take some pictures if problem persists. Do you think the...

It does have a o ring on extractor spring. I removed it and will try. I have cleaned everything and will lube it heavily. I also will try sarduy recommendation along with the others. Thanks Jeff

Not sure what you mean. It is extracting and ejecting. The round in magazine is not being stripped. Bolt closes on empty chamber.

Its marked the same Jeff

I am using Federal 5.56 brass case fmj. Bolt is not locking back. I took the gas tube off and realigned it. I have not checked the gas key but I did use BCG from my other AR. I am leaning towards gas block

It is doing it on all mags. Factory colt and others. I did clean gas tube and only have maybe 50 rounds through the upper. Thought about a adjustable gas block However I didn’t want to just throw money at the problem. Jeff

My AR upper is a Frankenstein. The upper receiver is supposed to be a S&W but seems to have similar markings to Aero. The bolt is Areo and the barrel is a ? 1:7 Wylde chamber. Seems to be very accurate. Here is the issue( most of the time) it is a single shot. The bolt starts to strip cartridge...

I am not sure but most likely a reload, I was not on the hunt with him. I removed the case when he got back home.

I had another friend that had a case head separate in a 7 Mag Remington 700. He was hunting and shot at a deer. Tried putting another round in and couldn’t. He was not hurt, gun was fine and I was able to remove the case from the chamber. I guess you never know I reload a lot and so far I have...

My good friend all but lost a eye this past December when his .270 model 70 pre 64 let go. Reminder to wear safety glasses. He had just taken his off to make a scope adjustment. Reloads? Yes!!. He pulled the Bullets and weighed the balance of the loads he had. All were fine. The case is still...

I have a 7mm Mag that is very accurate. 200 yard groups average under 3/4 of a inch. Gun has a brake and was purchased that way a couple of years ago. My wife had a mule deer hunt ant the only load I tried was a 140 grain Barnes TTSX over Retumbo. Put a Nikon FX100 on it sighted it in. She...