-
-
Aa5werkes replied to the thread AR-15 Gas key screws sheared.I bet it does. I have a gauge to specifically check that gas key - lower receiver ring gap tolerances. A fancy two quarter test. There...
-
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.^^That's a lot of elbow energy!
-
Aa5werkes reacted to Armorer 101's post in the thread What gunsmithing or repairs have you done today with
Like.
Did some sanding on the new stock for the 358 Win conversion. Have the metal work done, inletting and glass bedding done, just need to... -
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.Yesterday, making a lathe center gauge for aligning 60 deg tool bit for single point thread fabrication. I have the Browning & Sharpe...
-
-
Aa5werkes replied to the thread AR-15 Gas key screws sheared.Thanks for sharing.
-
Aa5werkes reacted to Buzznrose's post in the thread Daniel Defense Customer Service Review with Like.
Got my package. Very well packed. Very happy with the CS!
-
AI pulled the swivel from my Marauder due to bipod use. My Father would say, 'it's cheap plastic", others would come to find I abused...
-
Aa5werkes replied to the thread How can I remove an invector plus choke that won’t budge? Tried a lot of tool but still no deal. Any solvent ideas that could help? Need a miracle ..Finished my doomsday choke tube driver set.
-
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.Interesting demonstration of the how a small tap wrench is Not a precision instrument. You may want to consider avoid using the...
-
-
Aa5werkes reacted to 45 Dragoon's post in the thread What gunsmithing or repairs have you done today with Like.
Exactly!
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.You set yours up like a Fordham rotary system.
-
Aa5werkes replied to the thread What gunsmithing or repairs have you done today.Not a gunsmith repair but rather a nice inventory upgrade; a small bench top vise for holding small micrometers in particular. I find...
-
-
Aa5werkes replied to the thread How can I remove an invector plus choke that won’t budge? Tried a lot of tool but still no deal. Any solvent ideas that could help? Need a miracle ..........a different approach for the Browning universal choke tube wrench. Akin to a wing-nut hex bit driver.
-
-
Aa5werkes replied to the thread How can I remove an invector plus choke that won’t budge? Tried a lot of tool but still no deal. Any solvent ideas that could help? Need a miracle ..Most likely the damage will occur due to compression / distortment of fine choke tube threads, from the expansion of the Brownells'...
-
-
-
Loading…
-
Loading…
-
Loading…
