Recent content by anbrumm

Thanks for all the replies guys. I am going to order some .356 or .357 coated lead to try out. It looks like using the same taper crimp that I use on the plated should be fine.

I have been looking at coated lead bullets, but have never messed with them before. Do you crimp them just like crimping a plated bullet? I have seen a lot of people mention .356, but some of the companies I've looked at for coated lead show as .355. I was looking around, it looks like a lot...

Just placed an order for 1k 9mm and got the first time buyer free shipping.

Making the most out of apartment living. A real bench will get made when I buy a house. Loaded up my first big run of ammo tonight.

Cool. I just wanted to make sure. I was a little worried when I picked it up and saw that being it was within my first 250 rounds total loaded.

All my brass is once fired. There is the possibility of it being a stray that got picked up with my brass. Added headstamp / primer picture.

Hello all, I am new to reloading, and found this while picking up shot brass the other day. I was shooting through my first 200 rounds (after working up a good load). I picked up this case that I saw it was split. I am loading 4.55 gr of Win 231 under a Berrys 115 gr. plated bullet. This...

I am currently loading for about 15 cents per round. It could be a little cheaper, but I bought my bullets by the box of 250 because they were out of both 500 and 1000 boxes. This added about 15 dollars to the total cost. After using this batch of bullets my reloading cost will be closer to 12...

How many are you looking for? I would have to count, but I might be able to come up with around 50 or so. They are once fired Winchester brass.

Very interesting story on how you got your start into the bullet business. I have already bookmarked your page to keep in mind when I get through this 1000 berrys I bought. I am always open to helping a smaller well run company succeed.