Recent content by clement1

Ooops... I got it...I missed your detail. CC

It shot to point of aim... Slam...thanks...what weight bullet were you using in your Webley? clement

I have a MK VI 455 Webley...it has been partially shaved for 45 acp 1/2 moon clips but the inner star on the ejector is in tact so it can still use factory ammo as well as cut down 45 colt cases which I am going to use. (about 20) Does anyone have load data for this type of handload. I am...

ARE THE EXTERIOR DIMENSIONS OF AN 8X57 J (The original 8mm ammo for a GEW 88 Commission rifle) DIFFERENT THAN A modern 7.92 8MM CARTRIDGE. I would like to find out why a standard 8mm cartridge BRASS, not loaded ammo, would not fit in my Gew 88 commission rifle. Now I know that the ammo is...

ARE THE EXTERIOR DIMENSIONS OF AN 8X57 J (The original 8mm ammo for a GEW 88 Commission rifle) DIFFERENT THAN A modern 7.92 8MM CARTRIDGE. I would like to find out why a standard 8mm cartridge BRASS, not loaded ammo, would not fit in my Gew 88 commission rifle. Now I know that the ammo is...

I have an antique GEW 88 that I have found to have a very old broken brass casing perfectly lodged in the chamber, and very much completely taking up the entire area just prior to the actual barrel. It is so fused in there that I was not aware of it until I tried chambering a round to find...

That would be me...I hope that foxcarbine.com will have them soon. They are working on renewing the interest in these unique carbines.

Hello there. I have a semi-auto Fox carbine in 9mm. Not the greatest rifle ever made, but as an open bolt carbine it is lots of fun to shoot. However, I've noticed that it is missing its extractor(!) and perhaps a retaining spring. So now I'm in the hunt for that part... Does anyone have a...

Yes the barrel comes out easy, that's the no brainer...but the bolt is a different story. Hope someone has an old instruction manual.

I need need instructions for cleaning the internals of this carbine. Does anyone have a manual/PDF or just could sent me instructions for take down/ dissassembly so I can clean the bolt and firing pin, etc. Thanks. Clement [email protected]

RE: Acceptable FFL sending I contacted a large Gunbroker dealer, has a store in CT, and they accept emailed FFL's...seems to be quite OK. Would still like to find where on the BATFE website it addressed the issue.

I have a question regarding the proper, acceptable, and BATFE approved methods of send an FFL license copy from one dealer to another. I can not find the section on their website (BATFE) that addresses this issue. In the old days it was common practice to send an ink signed copy along with...