i am not leaving the screw #10 in the diagram unseated because i want less trigger pull its just that the hammer and trigger are locked up unless that is not fully seated:confused: and when it is not fully seated i have too much slop in the cylinder rotation and i am only getting 2 clicks when...
new revolver functioned ok little rough took it apart installed wolf spring kit and smoothed some rough edges, put back together and cylinder and hammer lock up unless i dont tighten trigger spring all the way down this happens with stock spring also, if i leave the tension off the trigger...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.