Recent content by curlysir

Received these case feed support clamps for the new 5 tube case feeder last week and installed. Just what it needed. https://www.etsy.com/listing/1678608610/5-tube-universal-case-feed-support-clamp?click_key=7ea52e5a457e39cca6352468c7457916d388f9c3:1678608610&click_sum=46e26a00&ref=hp_rv-5

Have you tried the LEE .40 S&W /10mm AUTO CARBIDE FACTORY CRIMP DIE. I load a lot of 10mm and this is what I use for a crimp tie and I really like it. I have not had a problem with scratched case using the factor crimp die. The die is $21 plus shipping and taxes at Titian...

Ordered 2 of these on February 2, 2024 and received them today February 13, 2024 via USPS, 11 days from Norway.. No tracking number or delivery notice from USPS, it just showed up. Have it setup and tested but have not actually loaded with it yet. Does appear to be a very good option vs. the...

Get you a set of these. Much better than the Lee Ring Wrench. Can be bought from Amazon or Lowes's as a set for around $11. The 1/2" fits the Lee Rings. https://www.gardnerbender.com/en/p/LNW-KIT/Locknut-Wrench-Kit-includes-one-each...

Yes, I had them my cart to check Shipping. Hopefully it will be available from Titan soon. I just placed an order today with Titan and Shipping was only $6.75.

Was going to order a couple, but shipping would be $16.50 for 2. Will wait until I need some more stuff.

Another vote for the Satern Funnels. I have the Satern Funnels in .22 Cal, 9mm, .40 Cal/10mm, and 45 Cal and really like them, tried a couple other brands before I found them.

Has anybody come up with a solution for stabilizing the inline bullet feeder magazine on the inline bullet feeder? That is the major problem/annoyance I have with the inline bullet feeder, I do not like the way it "wobbles" when setting on the bullet feeder die. I like the way the Inline Single...

My brain was not in full function mode when I first read the above post about the collator. I did purchase the collator but have not installed it yet. It does appear to be a good design.

I also purchased the collator, have not installed it. I do not use a collator very often.

I have 2 of the silver ones on order, they have shipped.

Something along that line is what I plan to do. Plan on putting something is the middle like another tube or wooden dowel. Just got it mounted and haven't had time to do it.

Just installed the UNIVERSAL 5 TUBE CASE FEED MAGAZINE and very pleased with it except for one thing. I do not use a collator and The tubes need clips or a top cover to stabilize the tubes. Does anyone know a source for tube clips for the 5 tube magazine like I have on the old tubes. I have...

After I installed the missing part on the Auto-Drum and installed the Update Kit I installed the Auto-Drum on the press. It will rotate freely but not free enough to rotate on its own. The Swivel Adapter takes a little effort to turn with the missing part but not enough to be a big deal, it is...

I knew that when I ordered. It was a last minute decision to order the expander and it was after hours. But it was just $4 so no big deal if it wasn't the new style. I just installed it along with the upgraded Auto-Drum. I had to back out the expander a full turn, not sure if it was the new...