Ok thank you I'm not sure how to calculate it and have been trying too. I called the barrel manufacture and they said should work but wouldn't give me any details. Beings that they sell savage pre fit barrels at 1.06 so idk
Ok I found a calculator online for the hopp. I put in .534 for the cartridge and subtracting that from 1.17 and adding in 65k psi gave me 77475 my barrel is stainless 126,000 so do I dived that number if I do it gave me 1.6 which would be over the safety factor of 1.5? Never done this before so...
Question: when tapering a barrel and threading the barrel shank is there a minimum amount of metal that has to be behind the barrel shoulder?
For example a 28 inch barrel threaded for a Remington 700 with a oversized recoil lug in a 338 rum. Behind the barrel shoulder where the recoil lug sets...
Hello
I'm trying to see if anyone out there had rebarreled a Weatherby vanguard .
I know the specs are 26mm with a 1.5 pitch however I was looking for info on cutting the counter bore for the bolt nose. I have a cutter for a .705 for the Remington 700. But it appears to be too big. Anyone...
Thank you everyone for replying I will look for classes and start with solder and brazing . The only reason I speak of a cracked action is because a gun smith here showed me an old mauser action that had a crack near the ring of the reciever so he exposed the crack and used silver solder to fill...
Thank you for the advice. Yes that is correct I do have very little experience. I guess my question should say should I start out with soldering and gas welding to learn? I do not plan on doing cracked actions for other people or advertising to do so but to learn under a very experienced mentor...
Hello all
I am looking into purchasing a welder to do small jobs.
Example fixing a cracked action,attaching sights and a bolt etc
My question is im not sure I can afford a tig setup. Will gas welding work for what I want to do until I can afford a tig setup? I know that everyone says stick...
Hello all
I have a savage 116 that I'm looking to re barrel to a 338 rum
My question is ... Is there any benefit or added strength by threading the barrel off the shoulder like a 700 opposed to threading the new barrel without a shoulder to accept the barrel nut?
Also is there any logical...
Hello all
I'm looking at rust bluing. I can do hot bluing but it a small shop and cost it takes to much. I was looking at rust bluing. I really like the way it looks and I enjoy the work that needs put into it it's kinda like a custom touch.
My question is what's a good solution to use...
Does anyone know about
M-1 rifle cal 30-06
Made in the USA by A I St Albans Vt
I found a receiver for sale and I'm reading that there made by century and imported anyone have any experience with these?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.