Recent content by GilaMonster

Is there any difference? I am about to use up my IMR 700x, and move to an 8lb jug of Hodgdon 700X. Can anyone say definitively whether or not there is a noticable difference between the two? Should I work up a new load for 207-gr LSWC .45s? Or use the same charge I have been using with...

Glad that your order of BulletHeads turned out better. I originally posted the negative review in the "Where are there reloading components for sale?" thread. The 1,000 I got certainly did not look that good. I may have to try again, based on your positive review and measurements... The...

GilaMonster, thanks for your post. You're welcome...and thank you for this thread. Appreciate all the work you put into it! The recent feedback reports I have checked on several forums have been positive. Mebbe I got a bad batch. But, after a few of the rounds actually fell into the neck of...

Quote: Bulletheads (Made in USA): 223 (.224") 55 gr FMJ-BT with cannelure (Free shipping) - $87/1000, $340/4000 - http://www.bulletheads.com/ Just a heads up: On the recommendation of someone on another forum, I bought 1,000 of these from Bulletheads, for $90 shipped. They were...

I have to agree with CD8226. I have used TiteGroup in both .40s and .38s, using WW-cast bullets. I find it shoots cleaner than Unique, and I have seen no leading at all with Titegroup, in either my Security Six or Ruger SR40. I find it to be soft on recoil, and accurate, for the rounds I load...

ummmm, maybe that was SAM Adams? President John Adams' second cousin? John Adams was a lawyer, and as far as I know, never owned a tavern. and actually, Sam Adams' family were 'maltsters' -- provided the malt to brew beer -- but were not actually brewers. Perhaps it is their 'malt house' to...

I load 185 gr LSWC over 5.5 gr of Power Pistol for my everyday practice round in my Ruger SR40. Never have had any problems...

I have that list, from my .357 die set. Our scanner is broken, else I'd scan it and email the pic to you. I could make a copy and send it snail mail -- PM me with your address if you'd like that

I have been working on putting together an order of reloading and casting equipment, comparing pricing and availability, thru Midway, Factory Sales and Titan Reloading. When I ran across this thread, I added Graf's to the mix. I compared my two shopping carts with the exact same items and...

I have had good luck and good service from Mike over the past 3 years...ordering loaded ammo from my supplied brass. I am now about to send an order for cast bullets, as I have begun reloading my own. my only complaint: I sent almost 1,000 rounds of brass separated by .38 special and .38...

this is kind of pricey as well, but looks like it works http://gunblast.com/BrassGrabber.htm Jeff Quinn over at Gunblast did a review of this brass catcher glove