There is no slot cut in the back.
Yes, they do have a little bit of an over hang.
Thank you i didnt think that they would have soldered the front sight back on, and refinished the revolver.
"At the time they didn't offer the M&P .38 with a 3 1/4" barrel, just 4, 5 and 6 inches. Why...
Thank You, I found the number under the barrel and it is the same. the barrel from end to end is 3 1/4 in long. I do non't think it was cut because the crown is still there and there is bluing on the tip of the barrel. How can you tell the wood was replaced?
right side of the barel is stamped 38 S&W Special CT
right side under the cylender is stamped
Made in USA
IA co SAC CA
When the cylender is lowered ther are a couple of places where it is stamped 46415
the bottom of the grip is stamped 417853
the barel is very short only...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.