Recent content by Jaymo

I have some 4756 that is 28 years old. Still good.

Unless it's the BRI sabot slug sold by Winchester. Despite their statement that they're only accurate through rifled bores, they were designed and originally sold by BRI to be used in smoothbores.

I had an FEG HP in the 1990s. Wish I'd never sold it. Live and learn the hard lessons.

Those little 1862 Pocket Police revolvers are sweet.

No, but now I'm going to have to find out how well .32 HBWCs fit the chambers of my Uberti 1849 pocket .31.

I bought my new Uberti Pocket .31 this year. Yep, they run about $350 EACH now. Two of them. A nice case. A mold. A flask. That combo does not come cheap. Buying them all separately would easily cost over $1,000 new. My question is what are the grips made of? If they're bone, ivory, or elk...

Will do. However, It's done it since 1995.

Vigorously. I always cycle my pumps vigorously. Both the receiver and the barrel are marked Magnum.

Long story short, in the mid 1990s, I decided I was tired of lugging my 12 gauge around all day when hunting doves, squirrels, and rabbits. So, I bought a nearly new 870 Express Magnum from a local shop. I hunted with it and enjoyed how much less it weighed and kicked. It's always cycled 2-3/4"...

I have a pair of those holly grips from Private's. Bought them from him when the Ruger flat top .44 Special BH came out. They look closer to ivory than the resin based grips. Gorgeous grips. prefect fit.

I'm a big fan of the 5.5" barreled Pietta Remington .44. It's handy and balances well in the hand. I'd like to get a couple more. one to give me a brace of 5.5s, and another to make a bulldog a la Mike Beliveau.

My wife sent this trailer to me a few days ago. I've got to watch this movie.

There were guns in that video???

For the record, I strongly prefer lead shot.

What about using shot wraps inside of shot cups, with the bearing balls as shot? The hardness of the balls is of no consequence, if the balls don't touch the barrel.