If you touch that M41 with a Dremel you will be excommunicated from the ranks of those who cherish this fine pistol. Clean it shoot it and...
Since I figured out hardness is the leaser of the issues facing bullet casters I haven't checked hardness in 20 years. Maybe I'm lucky to have a...
Gee! NO bids!!??
I have 14 1911's! 5 are Kimbers, three for EDC, two for pistol games. A 9mm CII 5" that has a zillion rounds down range shooting matches for the...
Lifetime membership in anything shows you're totally committed! Endowment since 1972!
.223 Remington and 5.56 are the same at SAAMI Spec's. "The.223 Remington cartridge is specified at a SAAMI max pressure of 55,000psi compared to...
The first challenge will be getting past EPA permits. There must be a reason there are no longer ang lead mines in the US! The only lead being...
Use it the same as any other mid burn rate powder. such as what you would use for heavier bullets in 45, 9mm, 38 Super, 38 Spl and 357 (non magnum...
S/A pistols rely on a balance of springs and proper maintenance. Couple that with out of spec ammo and magazines and reliability suffers, a lot!...
As a competition shooter I found it best to have specialty glasses just for shooting. I found an optometrist that also shoots so bringing in my...
I have the NOE 135 grain RNFP that is .358 diameter, I then size to .357. I use lead that is around 10BHN. Not considered "hard cast"! I use a...
Aside from the obvious security reasons: When selling it's all about perceptions and presentation. The house should have minimum furniture and...
I'm not OCD I'm not, I'm not! Over the last 35 or so years I've accumulated 5 Dillons (SDB's, 450Jr's and a 550! for each of the pistol calibers...
The problem with the small 9mm case, COL and 147 grain bullet is getting factory velocities within SAAMI pressure specs. As in the above example...
Separate names with a comma.
