Recent content by js2013

CZ P10c - about $500-ish. Some folks saying it's better than the G19. Time will tell. Should be shipping in decent numbers in 3-4 months.

I tried the B6P compact and liked it for the most part. I didn't like the trigger over travel but that was easily fixed. It also worked fine with the CZ75 mags we had. Safety was a little on the stiff side but perfectly acceptable on the one we tried. IMHO it's a darn good value. We put over...

Ahhh the first match.... The one you'll never forget

There's no chart. It has a lot to do with how concentric the bullet itself is and the chamber, how concentric the bullet enters the chamber, etc. All these types of errors get amplified the farther the bullet travels. Folks interested in extreme accuracy measure this stuff to 10 thousands of...

Can you get a good cheek weld with that stock from the prone position?

Not sure if anyone mentioned it yet but felt recoil IMO can be reduced by going to the next size lb up recoil spring (I think it's 19lb but check) and there's a few online trigger job tutorials that are decent.

61% And that's just for fmj. The number can be larger.

What's your FPS spread with RL17? I tried some in a 6xc and my SD wasn't as good as I would like. Some guys seem to like it but like you said, most folks are using h4350 but its hard for me to find locally.

Wow! If the CZ is outdated what does that make the 1911! I still like hammers the best. I must be outdated too. Try the CZ, if you like it buy it.

I bought one of the first pt1911 and never had a problem with it that I can remember, reloads or factory. It had a full length guide. The finish was just OK, but good enough for me (if you shoot/holster a lot any finish will wear eventually) accuracy was ok, trigger was ok, but for the price I...

Of the options you listed its a no brainier, RPR in 6.5. Tubb won a national title with a 243 but there's better 6mm cartridges with longer barrel life. If you prefer 6mm (like lots of 6mm bullets on hand or prefer less recoil) then go 243 until its shot out and re barrel to a better 6mm. Or...

I tried both. I liked the 19 much better than the stock or the 21.

Very nice! Not too many people will take the time or have the craftsmanship to do what you did. BTW did you weld on a new bolt handle?

"Call Frank White at Compass Lake Engineering. He'll fix you up." Good advice!

Fyi - tried both small and large primers. No problem with large and will buy again. Small ones were not 100% reliable. Several took multiple hits to go off in both striker and hammer. Same reloading procedure as used with other primers (cci, win, etc) which never had a problem. Primers were...