Recent content by L-

Did you take the bolt apart? If not then do so and check for a cracked bolt. There is also a raised portion (?) that also fits in a track, semi circle kind of thing. This is the block that fits into the back of the barrel. See if a piece of the ridge is broken off. There should never be...

http://www.youtube.com/watch?v=jkiGWd6ot84 This will help you on the friction piece arrangement. IF you decide to take yours apart then be careful as the receiver is razor sharp where the trigger housing rests. Also, replace the action spring and the action spring plug and maybe the pin...

The buffer is kinda easy to do. I get mine and the rivets at SARCO. Pry the old one off. Use a taper reamer, the long kind, not the 45 degree one, and lightly open on both sides. Place it over the existing rivet. I use a piece of round dowel like a broom handle through the front of the...

Use a pipe cutter and oil the cutter and rollers. Don't clamp down too hard. Works perfect if you don't have a rib to contend with. The outside of the barrel will be smooth and rolled by the cut. The inside can be smoothed by shooting a #4 and a 00 shot shell at a 11 X24 " paper with a clean...