Recent content by mantawolf

Without the source code a scan won't tell you anything about what the application is doing. Again no offense to you but you have 12 posts on this site. Sent from my Moto G (4) using Tapatalk

You all are welcome to click any link you want and install any software you want, but as a software engineer I would not install random executable files from the internet from people I don't know. No offense to op Sent from my Moto G (4) using Tapatalk

The military doesn't do the exposure so you can learn to operate under exposure, they do it so you learn to trust your gas mask. Sent from my MotoG3 using Tapatalk

My 11 yo daughter loves her Beretta mouse gun, and hers is fairly accurate Sent from my MotoG3 using Tapatalk

I have used the below before for 5.56 brass, could process 500 cases in less than an hour. http://www.giraudtool.com/prod02.htm Have never used the tools you referenced tho. Sent from my MotoG3 using Tapatalk

+1 for a petzl tikka, I love mine. I also bought the rechargeable battery for it.

The hornady boxes can be ordered from midway.

You can order the hornady die boxes that are designed to hold the dies with the bushings in them. Also believe that mtm makes a box that will hold them.

I have no issues with Lee dies on my LnL, I am also using the case feeder and have no issues using it personally.

Absolutely can not interchange berdan and boxer primers. Anvil is built into a boxer primer and built into the brass on a berdan primer. You can hydraulically pop out a berdan primer but they make a tool to do it that is similar to using a claw hammer to remove a nail.

80gr is a long bullet for an ar magazine. You could in theory start low on your loading and work up to something that works for you. Seating deeper will cause more pressure to develop inside the case, too much pressure can cause problems and rupture cases

I was not able to pattern with 55gr bullets in mine, went with 77gr hpbt instead. Sorry I am not help with the 55gr either