Recent content by mortonman

I've never been a fan of any .380. I've fired Keltecs, S&W Bodyguard, Ruger LCP and Walther PPK . The PPK wasn't bad other than being picky about ammo. Swore I'd never own any .380. About 2 months ago I saw the RM380 and it kinda got my attention. Did some research and the reviews were positive...

Sure is.

They're pretty much the same. Here's a good article. http://www.leeroysramblings.com/remington_740-742-7400.html

Good deal. I hope you get it shooting soon. Bob's gun parts looks like a good source.

I ordered the parts separately from www.gunpartscorp.com. 2 bolt latch springs part #88580A 1 bolt latch pivot pin #88570A 1 bolt latch spring plunger #88590 I installed a spring and the bolt latch pivot pin in the hole next to where the bolt latch hooks in. Installed the other spring and bolt...

I successfully repaired a 742 about a week ago. Replaced the extractor, bolt latch plungers and springs (they were missing), smoothed out the receiver rails, polished the chamber and lightly filed and polished the magazine feed lips. It did fail to extract with a light film of Break Free CLP in...

You could try a Co2 discharger. Dixie gun works has them.

I love my Glock 20sf. Midwayusa.com has Doubletap 10mm in stock, its expensive but its good full power ammo.

I have a Fusion 10mm long slide and a Glock 20 SF with a stainless guide rod and 20# recoil spring. Fantastic guns chambered in the perfect round :) I'd really like to have a Colt Delta Elite too!

You may want to contact Fusion Firearms. They offer kits and complete pistols. http://www.fusionfirearms.com/ My Fusion 10mm is great!