Recent content by mtarnold5

Worst reliability Sig Mosquito!!

Small 9mm Look at the Rohrbaugh R9 & R9S, they are pricey, but fit your bill perfectly. Take care, Mike Arnold

Jennings/Bryco I am not surprised your bryco hasn't hiccuped......they are made to function properly, and you probably take good care of it.. There is a place for inexpensive guns like these...........however, a couple of people asked on this thread if there were any options under 200 for...

Makarovs P.m. sent to Drgong with links to several options. You might also consider the CZ82 (9x18).....they can still be had for right at 200. Check J&G sales........ I gotta tell you though, if you are going to put your money into all these zinc pistols (jennings and ravens), you might...

Jennings Holy cow.......I wouldn't waste my time......but, have you checked the springs (recoil and magazine)? As someone else suggested, try polishing the feedramp..... By the way, there are options under $200 that are much better. FEG PA-63 (9x18) Bulgarian Makarov Good luck and...

Well then... I guess I must have misread ......" not calling u out or anythign but just ain't buying it" . OK then, my bad....... explain to me this then......why would Craig get on here and say Ruger stated his frame had worn out? What would his motivation be? It is obvious that no matter...

hmmm..... hey jocko, I think that it is spectacular that you and your boyfriend have a combined 9000 rds through your lcp's. I hope the next one you gets gives you no problems either, however, you "calling out" another forum member because they give THEIR personal account of THEIR GUN is...

3 gun picture Hello, That picture of the 3 cz's is so cool......those are my 3 favorites I have. I WILL also get an sp-01 when possible. Take care, Mike Arnold

Ribbons I received mine today!!! They are spectacular! Thanks, Mike Arnold

cz97 When I purchase any pistol, the first thing I do before I take it to the range is give it a good cleaning and polish the feed ramp. I had read where the 97's had had problems feeding hollow points......so on top of the regular fluff and buff I replaced the springs. In answer to your...

houges I currently have a few cz's with houges.......I love them! I have the opposite opinion of Walt, as the houges position my fingers perfectly! I prefer them to the pachmayers (which were tooo fat!). The cz factory rubber grips are awesome. They are thin, ergonomic and (grippy?). Mike Arnold

cz97 I also own a 97 and it is without a doubt the best .45 for the money available! I have not had any problems feeding hollowpoints. When I got it I just polished the feedramp, installed a more powerful mag spring, and put a heavier recoil spring (20#). If it fits your hand well..........BUY...

clarification NAVY BLUE FOR ME!!!!

pre-order Put me down for 10 of the #2 design. I would like them in blue! Thanks, Mike Arnold

favorite ribbon I like design #2........ I would take 10 of them!