Update: took the gun to a local gunsmith. He looked at it and said the firing pin bushing had been replaced, but not well, and was what was snagging the snap caps and bullets because there was a small burr on it and it wasn’t flush with the recoil plate (back of frame?).The firing pin hole in...
At half cock the hand has resistance when I push it in and then it pops back upon release. At full cock it protrudes out beyond the rear of the frame (the recoil shield) and there is resistance when I press it back in. Taking my finger off of it allows it to pop back out. This Pietta's hand...
I need to narrow it down to which chamber it is, as suggested, and then look at the gun and using the advice I have received so far on this thread. It seems to only happen on one or two chambers. If still perplexed I'll take it to a gunsmith here in town and go from there. Aside from that the...
Yes, it does. I had asked EMF to look at that problem and they said they fixed it. When I first got the gun it was happening quite a bit w/o ammo in the chambers. It worked itself out to the point I am at now.
Hello revolver aficionados. I got a Pietta Great Western II Californian a little while back. No sooner than I got it and off it went to EMF for warranty service. They fixed almost everything wrong with the gun, but something still seems to be amiss with it. When I cock the hammer (four clicks)...
Great, thanks.
I shot my 327 yesterday for the first time with Federal 85 grain defense, SW Long and S&B wad cutters ammo. So much nicer than shooting a S&W 642 38. That was no fun. This gun was a pleasure to shoot and accurate at 7 yds. Very happy with it.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.