So, how do you secure the shim in the bottom of the barrel? I started with the shim-in-the-barrel approach, but couldn't figure out how to keep it in place.
Jason
Thank you.
I did indeed think about covering the dividers with material and making a seal-strip but was concerned I wouldn't be able to trim the material precisely enough. Following is a picture of a real Colt and presentation case with the dividers covered with a blue felt-like material, which...
We've had quite a few rainy days here recently in Houston, Texas which has forced me to seek indoor activities. So, I built a wooden storage case for three of my torque wrenches and then I built a wall cabinet that holds ten sets of steel-point darts and also serves as a beverage shelf...
Indeed, the arbor on Uberti Walkers has proven to be too short in many instances. There are two ways to fix the problem: make the arbor hole shallower, or make the arbor longer. I decided on the later and used my little 110V MIG welder to build up the end of the arbor to a length greater than...
Ubertis typically come with an arbor hole that is too deep. Even if you think that the arbor is bottoming out in the hole in the barrel, it's probably not. Instead, the end of the arbor probably jammed toward the bottom of the arbor hole without bottoming out. Measure the depth of the hole and...
Thank you for the explanation. So for the above example (41-13/16") it would be equivalent to a 13.3" diameter, which is pretty tight considering the distance?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.