Recent content by Prose

Chambered Chambered Chambered Chambered Chambered Chambered Chambered Chambered Chambered Chambered I hope you read it out loud. Then you might remember it. Cause when the suck happens that is the last thing you need to worry about. Concerned with loading and unloading? Keep it in the...

Clinton was a Democrat. Not a Marxist.

I talked to my brother who knows a little bit about wheel guns and he thinks that perhaps the firing pin spring might be bad. I looked at it again and it did not protrude as much as it did last I looked. recocked it again and the FP seems to stick out again. At least that is one thing that...

Go buy about 500 rounds of ammo and pound that thing. Look at it this way... If you had a beautiful girlfriend that loved you, you would pound it. That gun loves you. Love her back. Never keep a lady in waiting.

I was at a gun show recently looking for something to replace my shotgun (I hunt deer in a shotgun only zone). I bought a S&W Model 629 .44 magnum. It was used with and has a custom trigger job (Who done it I have no idea). It is very light and if anyone else should shoot it I would point it...

Any specific time frame on the release date?

Switch to glide. Point the gun at the target. Imagine the trigger pull as a gliding sweep. Like a swing on a swing set in slow motion. Concentrate on the action of the trigger finger. 100%. Tell her to COMPLETELY focus on only ONE thing. And that is the sweep of the triggerfinger as it...

I am gentle about loading the mag into my XD 9mm. However, recently I was in my backyard and I um... basically lined up my full mag in the handle and kind of hammered it in pretty hard. The full mag slammed into the gun and the slide rammed forward and chambered a round without me touching...

I can give you some advice that may help: I am very proficient at rapid fire. I am capable of unloading a 9mm 16 round clip at a rate of speed and drilling the target at 25 feet that makes everyone at the range watch with genuine interest, not annoyance. I have put many rounds through a...

LOL this is hilarious. When I got my Carry Permit this is one of the first places I went. And to tell you the truth this is the reason: For some reason I cannot explain Walmart is a place I thought I would feel comfortable carrying in. Maybe because their ammo prices are very nice...

I will tell you this: Shot placement is paramount. It's more important than the caliber. Steel guns are heavy. Big rounds in a big gun means a bigger gun and not as many rounds. So on and so forth. Usually weight is involved. Go get yourself a high capacity 9mm. You get 16 in the stack...

I own a P3AT. It is a superb little piece of equipment. It takes punishment. I am a little shy about telling everyone what I do to my guns, but to make the story short I tend to make a gun sweat before I carry it. When I mean sweat what I really mean is I actively go out of my way to break...

Just this moment I took my XD-9 and took a closer look at the slide release. I can see how it could be difficult to release the slide for some folks for a variety of reasons. That is, if you have your thumb on the flat side. However, when I use the slide release I put my thumb ON TOP. That...

He said pocket gun... Put it in your shirt pocket! Or light jacket or anything that has a shirt pocket that is inconspicuous. That's what I do.

I just bought a new P-3AT. Fired 150 rounds through. No problems whatsoever. Incredibly Tiny. It can go in a shirt pocket or any other pocket for that matter. I also have a Jennings 22. It's old. Works flawlessly. I will NEVER carry it, lol.