Recent content by rockns

state capital demonstrations Feb. 8 2013 https://www.facebook.com/2ndRight?ref=stream

:neener::neener::neener::neener:

bad word detected

I had a similar issue, found a post to use small file and lightly smooth edges not round just free of burrs and leave outer tube around primer tube loose, no oil on the parts.

Ive been there ten times and missed it every time:banghead:

The 1911 doesn't do to much more than your 38 only holds 2-3 more rounds, weighs twice as much, twice as big, bullets a lot slower, but bigger that's a plus, the 1911's seem to be a little more picky on what ammo you use, if you want more ammo capacity and larger round and better reliability...

does anybody have load data for 40 S&W 165g JHP with unique can't find it, usually load 180 LFN with 5.4g but can't find the load in unique anywhere can find it for 180,150?

most likely you will draw more attention than you like around campus but Preachnhunt mentioned Court Days in Mt. Sterling, Ky. in October if you like guns this is something you don't want to miss but you really should have started saving money last November for it.

I went from the Lee turret to the LNL AP there is no way I would go back much better and easier

if you have a tubing flaring tool take out the die and use the tube holding portion to clamp on bullet and pull ram down removing bullet from case

I have a friend I think that can make that happen but I have been looking and the Lee's aren't that high, so may just get one instead of modifying this one

OK measured and 4 1/2" from top of ram to the bottom threads. and 4" stroke takes a standard die though.

I need a little help from somebody that loads for a 50, I have a large older midway press that I think may work but could use some measurements like ram travel and opening between shell holder and die theads