Recent content by sandust

Been messing around reloading for my SIG P238 pistol. I wanted to get some more weight than the available 102 grain max factory loads on the marked. Found loads in the Lyman 29th manual and these are the results. Thought I would pass it on in case anyone is interested in these loads. Before I...

It did eject the 7mm cases fine. I started playing around with it and I found that the cases lay in the action only when there is one round in the magazine. I have what is supposed to be a 375 follower and magazine box. But the follower seems to allow the front of the next loaded round to come...

Does any one know the name of a good gunsmith that can open up a Winchester model 70 classic short magnum action so that it can accept 375 H&H length cartridge. Looking for as close to factory action match as possible. I have a Model 70 classic stainless that was a 7 remington Magnum. I had...

yes, I know too well about the weight. And it was a consideration in the purchase. (Definetly OUT of my price range but I would love to have the AMSEC HS. But at 4000 +- lbs. You would have to rebuild your house if it has a wood floor just to get it to the spot you need it.) I work in...

Thanks for the response. A heavier mix sounds good, but too bad they went with thinner metal. Does AMSEC list the metal thicknesses anywhere? The bottom where you bolt it down to the floor is made of at least 1/8" material single layer. Do you know if the new mix adds anything to fire...

After reading the many Safe threads on this forum I decided that the BF6030 was the right cost vs value safe for me. The discussions from all the posters and dealers/experts here was invaluable in this decision. Thanks to all that posted. My my new Amsec BF6030 just arrived. I am more than...