Good call on pulling the bullet. Thanks. Pulled it and checked the brass. That 1 piece of brass needed the shoulder bumped. Checked the other 99 and they were all fine...all were trimmed to 2.005 as someone asked earlier.
I'm guessing that a piece of unsized snuck into my prepped cases...
Cases chambered fine after sizing and prep. Pretty confident in the sizing.
I tend not to crimp rifle loads and am not crimping at all in this load.
Sounds like a problem with the OAL gauge then...
I have been reloading for about two years and have recently decided to try to increase my level of precision by using a Hornady OAL gauge and accurately measuring jump to lands as opposed to simply relying on OAL length of the loaded cartridge.
Loading some .308 168gr Hornady BTHP's on...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.