Recent content by sgtwest

I load 150 gr Hornady interlock over 17.5 gr of IMR 4227 with vol 1900fps . so far good groups

My Savage .223 XP with Boyd's thumb hole stock It shoots like a dream .

I load .223 and 308 just wonder if anyone has had used CFE 223 or IMR 4166? if was so how was your results.

Thank you for all of your info , the Nikon scope would works as well on non AR type rifle.

looking for gen info for a spotting scope. gong to be shooting 100- 300 yards . What would you recommend for power and lenses size?Thanks

Do you plan on bedding your stock ? I have ordered an Thumbhole for my savage axis XP II .223

I'm looking at bipods, I mainly shoot from a bench and looking for good stability . I'm thinking a 6-9 be enough but not sure . any recommendations on brands . I 've most likely will use the swivel stud for my anchor point. unless there a better system thanks

I Have an short action axis with accu trigger I'm thinking about replacing the stock and most likely will probably glass bed it I found a resin kit from Brownells and a thumbhole stock from Boyd's for my project. any thoughts the cost of everything would be about 150. thanks

I like the .223 and 308 and 22lr but where I live 22l is hard to get unless I have the time to campout at the store. and in NY we can order ammo through the mail which sucks. in the 308 I like 110 or 125 gr for varmint and 165 gr for deer .

I shot .223 and 308 I like benchmark for .223 and IMR 4064 & 3031 has worked well for 30 cal .

I'm looking for a better scope for my .223 . I use 55 gr bullet with it 1 in9 twist. according to what have read in their advertisements that they can compensate for the drop. does anyone have any experience with them or something similar. 3x9 or M223 3-12x42mm Side Focus Rapid Action...

power for .223 Bruno shooing supplies has benchmark, BLC2, Imr4064 in 8lb I use benchmark so far have good results so far.

lubing rifle cases According to the Lee's modern reloading manual it states to lube inside the case neck with a swab. This should help. happy shooting

I use Mid South out of ten for my primers ,power and other components in general their pricing not too bad ,also you can be notified if there is a power you want if out of stock. Another place is Bruno's shooting supply he high but has a good deal of stock but a min purchase.