The mandrel for the Lee collet die is a little larger than the expander ball on your full length sizer die. Lee says that if you force the bullet into the smaller neck created by the FL die you will have some alignment problems caused by the uneven neckwall thickness on most brass. From my...
Thanks Bearman, the diagram should help if I forget where some doohickey goes. It looks pretty straight forward but I've learned the hard way that it's best to have some backup knowledge available.
Sid K
I'm going to clean up and tune a rifle for a friend that hasn't been shot in 25 years at least. Can you help with detailed disassembly instructions?
Sid K
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.