Hi All,
I have loaded some 9mm Luger rounds for a shooting buddy of mine and we went out to the range today so he could test them out.
Out of about 130 rounds, he had 2 stove pipes and 2 failures to feed (no failures to fire).
The gun is a Walther P99. He has shot about 600 rounds of...
Ordered the Redding Taper Crimp die from Midway. It's on backorder until mid July but once I have it in hand I will post the results!
Thanks to all for your help!
JB
Thanks for the suggestions.
In searching for a standard or taper crimp die...I see a couple options on MidwayUSA...Would it be the Taper or Profile crimp?
Taper:
http://www.midwayusa.com/viewproduct/?productnumber=709739
Profile...
Hi All,
Been loading .45 ACP for a month or so now with good results. I started with Montana Gold 230gr FMJ .451 and am eating quickly through my supply.
To save on costs I decided to order some lead bullets from Missouri Bullet Company. I just received 500 rounds of their 230gr .452 round...
Thanks to all for your feedback. I went ahead based on suggestions here and other readings regarding tumbling solutions and added two capfulls of NuFinish to my tumbling media (previously I was tumbling with the media and some cut up dryer sheets only).
I ran some brass through for a few...
Hello All,
Newbie here...been reading manuals and some forums for a few months now but never had anything to post until now.
I have a question for anyone using the Lee Powder Through Expander Die...
My setup is the Lee 4 Hole Deluxe Turret Press, with Lee Carbide die set (all 4 dies). I...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.