Recent content by slopoke

Thanks Jim and Bear. No half cock and I cannot see fireing pin protruding from bolt. This guy is a reputable gunsmith, has buit many fine 1000yd. guns and has always done right by me in the past. Probably will go back to him. Thanks again.

Just got my Marlin 39a back after trigger work. Gun will not fire rounds, no fireing pin mark on case. Apparently guy did not follow Marlins recommendations not to move lever after take-down. I don't think this was purposely done, the guy was just clueless. My problem now is I don't want to take...

I am sure someone has asked this before however I can't find answer. How do I adjust the trigger . Right now it is way too heavy for me . Can it even be done easily. Thanks for any help.

I want to do some roll crimping on 12ga. slugs on a drill press. How do you hold the rounds secure and straight?

Got a tumbler yesterday,no instructions came with it.Was wondering , how do I know when the corn cob cleaner needs to be changed?

Good thought,will try that. Was also thinking I may have to use some kind of epoxy or glass bedding if stock is too thin.

Do I install swivel studs in a Rem. synthetic stock differently from a wood stock?