Looked at the face of the extractor... I now believe this extractor was reworked from a .303 extractor!? Some finish polishing helped alot.
Thanks nick! I thought of that just after the polishing.... kind of stupid not to have thought of it before!!!
But with the extra finishing and cleaning...
Removed the extractor again, polished the sides of the spring mades sure no burs in the extractor pocket! Spring reset with retension nipple in its hole!
Extractor NOT touching barrel pocket at all!!
It still will not snap/slide over the rim of the case!:cuss::banghead:
New to the forum been gleaning info from old posts (not done yet)
Hope someone can help!!!!!
I have a ishapore .308 just purchase fired 60+ rounds! (loved it)
Complete brackdown (not counting firing pin) cleaned, oiled!
Went to fire agian and the bolt will not close on the round... the...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.