Recent content by tackbustr

RE: Info on the Browning B2000 shotgun Hello swampcrawler...tackbustr own in Texas here... I have a Browning B2000 in 12 ga with 30 inch full fixed choke... mine is a 1979 model, hand checkered , French walnut stock with a little tiger stripe running down it...its a beauty!:) I have shot...

Thanks for the replies! Will separate my brass Thanks for all the replies as to my case trimming questions RE: trimming my .38 brass....since I will be shooting only mild load 148 gr. wad cutters I think I probably will not need to trim for the 1st few reloads...however, I like Lee Roder's...

wow...nice Mdl 686... I have a 4 inch one w/ no dash number!!! Hello ...tackbustr here....you really got a fine lookin' 686 with beautiful grips and a rare no dash numbered one to boot. Good job.... 3 yrs ago, I came across a 4 inch 686 from a fella @ a local gun show in a table by...

tackbustr in Texas here.... getting back into reloading and have digital calipers and Lee max size OAL gauge ...but need an inexpensive tool for case trimming to correct OAL for .38 special brass(can't afford the crank type case trimmers) Will my Wilson chamfer and de burring tool...

Can I clean my brass w/ a brass brush vs a tumbler ?? Hello...tackbustr down in Texas here... I am starting up reloading after a 30 yrs I have a question on cleaning my brass... inside and outside cheaply I only reload .38 special wad cutters and can not afford a tumbler... (will...

Thanks for the advice fellas ....I will not use the Blue Dot for my .38 spcl loads... A fellow THR member and I are working on getting me some Win 231... that should be a better powder. tackbustr

Hello...tackbustr down in Texas here....getting back into reloading after a 35 yr hiatus... want to load up some .357 dia. 148 gr lead (but they look like hard cast??) solid base wad cutters that I just rec'd (from x treme bullets).... Can not locate any of my preferred Bullseye powder...

Thanks stubbie for the Lee auto prime kit Thanks to stubbie on the forum for generously giving me his Lee Auto Prime kit with many shell holders... he is a fine gentleman and may God bless him richly! tackbustr...down here in Texas :)

Many thanks to stubbicatt ! well...Stubbicatt graciously provided me with a Lee Auto Primer. Just a good example of the fine folks here on HR forum! Thanks again stubbie !! :rolleyes: tackbustr

Hello...tackbustr down here in Texas... really been looking for the old timey Lee hand held single priming tool...the one that you squeeze and only presses in one primer at a time....can't afford the new auto priming tool w/ the tray and like the "feel" of seating the primers by hand. please pm...

Hello THR members....tackbustr down in Texas here... this is my 1st message on this fine forum so please bear with me. I have recently been assembling reloading equip for another run at it (last time was 30 yrs ago) yikes!! :eek: I have all the equip I need except my old timey Lee...