Recent content by TB2Blazer

My 700 AAC SD 308 seems to like the 168 AMAX better than the 168 Matchking but both are fantastic bullets. If you do find some 168 AMAXs let me know I have been looking all over for them.

Its people like this, "I just bought all Walmart had, about 7500 rounds" that piss me off. Instead of just buying a few boxes to shoot they clear the shelves and either mark it up and sell it for three times what they paid for it or just lock it away in a safe for ten years. All while the...

A 9mm case full of lemi-shine, a good squirt of dawn dishwashing detergent, three hours in the tumbler and enjoy your beautiful clean brass.

I have had fantastic results using a vacuum sealer to seal up my ammo then throw it in the ammo can. I would imagine it would last forever that way.

You will just have to go by feel. Just put pressure on the ram till you feel it stop. It takes a good bit of pressure. You shouldn't have to worry too much about over seating it.

My press came with the large rifle primer on it. You can definitely tell the difference in the two just by looking at them. I wanted to prime some .40 with it and tried my best to get it off with a paper clip and it just wouldn't budge. Finally got out the needle nose and got it off. Keep an...

If it happens again and you cant get it out put the shell holder in your press and just use the sizing/de priming die to push it out.

I use bullseye for my .40 and like it a lot.

I just bought the big boss II and its awesome. To change the pin out for the first time I had to slide the little collet down and hold it with my fingers so I could grip the actual pin and unscrew it with needle nose pliers. I tried for a while to get it off the way you did and it was...