A P-01 was my first 9mm and my first CZ. My dad liked my P-01 so much, he went out and got himself one.
When I saw a P-06 in the used case at the LGS, I scooped it up. I love it. Recoil is very mild (I was expecting more from a .40) and its usually what I grab when I go shoot and its what's in...
UPDATE: I'm replying back to this thread to update all of you, and also to help anyone in the future should they have the same problem. Hopefully this saves you some trouble.
So I got the bolt disassembled again. I ran a .129" reamer through the ID and put a micrometer over the OD and a gage...
The whole reason the gun won't fire is because the bushing jammed in the channel, keeping the spring from doing what it's supposed to do. I will include the original bushing, but I'm going to ream the hole open slightly so that the bushing is free to slide in and out of the firing pin channel...
entropy: there isn't a separate detail for the bushing. If you look at the schematic on Numrich's website, the bushing can be seen as a sort of collar on the firing pin. There is a part on MidwayUSA's website that shows a firing pin bushing. For life of me, I can't figure out why a bushing...
Ok, so I got the firing pin spring out. Used a 8-32 tap and it pulled out something I didn't know it needed. A firing pin bushing. Looked at a schematic, and sure enough it shows it attached to the firing pin. Considering this was the source of my troubles to begin with, is a firing pin...
rcModel, the bronze brush is an excellent idea. I'm pretty sure I have an appropriate sized one at home in a cleaning kit. I also have a drill I can chuck it up in and smooth out the firing pin channel.
Thanks a lot for the suggestions guys.
Edit: Forgot to mention that I tried using a...
A fellow gun enthusiast co-worker suggested I try a wood screw of appropriate size to try to pull the spring out. If that doesn't work, I'll give the crochet hook a shot.
When I eventually do get the spring out, I'd like to clean up the firing pin channel (the spring obviously got stuck in...
Hi all, hoping you can offer some help.
I picked up a used Model 9 a couple years ago, and couldn't ever get it to run right. I replaced the powdered buffer with a BlackJack buffer, and put in a 21# recoil spring from Wolff and picked up a couple 20rd S&W 59 series mags.
The problem is...
I posted the same question on the CZ forum, and another member said his barrel had the same machining on it. I'll keep an eye on the forums, but I'm not concerned about it right now.
I will certainly check out the CZ forum. I have a feeling I'll find out something new and exciting, and start an all new obsession. These CZs just keep multiplying on me. Up to 4 now, and a 97B has been on my list.
Thanks for the link.
My question isn't about the finish. If you look at the picture, you'll see the material on top of the barrel is machined away, with the taper getting bigger toward the locking lugs.
Hi guys, went to a gun shop to look for used 16g shotguns and found a P-06 instead. Funny how that works...
I have a P-01 and love it to death. I almost bought a P-06 a few years ago, but couldn't swing the funds at the time. I saw this one and had to have it. Its minty fresh and I know I got...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.