Thanks RC. I don't know either, but a gentleman brought it in after a range session, with a box of new factory ammo. Only about 50% of them fired at the range, and it is obvious that the firing pin is not hitting them hard enough. I cleaned, oiled and inspected everything else and can find...
Has anybody changed the firing pin spring on a Kimber model 8400 (270WSM)? I have done a couple of hundred Model 70's, but the Kimber is a little different, and rather than just start experimenting, I thought I would see if anybody else has tackled this task. Thanks.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.