Recent content by twohightech

Thanks all, I will look at the sizing die as I never thought of that. Using a Hornady (PTX) powder though for a small bell so the bullet feed die to work right and have bypassed that step with no change. When you say a light crimp that should hold the bullet in place? When i back off the crimp...

I'm using Berry's plated 115gn bullets with a Lee factory crimp die. I thought all was good until i was cleaning lube off and some of the ammo got shorter. When I tried to add more crimp the bullets are still loose. I used a RCBS die with taper crimp to seat the bullet but unable to get that die...

what about in the freezer they will last a long time if you do not shoot much. Than they are those good 30 rnd clips that bullets stack into real nice. I feel what works the best for you is the way to go?

I think you have to spend so much to get cheaper shipping. Anything under a X amount they add a handling fee on??

Box them up and send them to me for testing....... I did have a Kaboom in a glock 19 with some reloads that was gave to me so do be carefull.

The show's around here have good deals on primmers, powder and can find few other things too. If you spend some money they will cut you a deal on the price and cash out the door. You will not get a deal on a 1lb can but get 2 or 3 8lb jugs you should. I keep buying reloading components from the...

My drive hub has been good but then the pawl broke it had a shell get smashed at deprimmer #1. I removed the brass and still had a stuck spot with the ram then i removed the shell plate the ram would not go down with out some force and the pawl broke? I have scince DEC got a case feeder and 2...

There were a few of us around the 1st of dec that this happened too as well. Took 11 days to get the replacement drive hub. I had a pawl that broke with me loading 9mm last weekend.

dlm37015 buying in bulk does make the price come down is that 1200lb left over from a ton? Is 37015 your zip code? Let me know if you need any help shooting it up. I will work for powder.

I hate the LnL ball wished it would spin. Nice looking roller handles on here but not for me. Thinking about a cue ball i'm sure it could be drilled. A bolwing ball might be a bit large?

I use W231 for 9mm and 45acp both

I'm happy with mil-surplus and not all of it is from pull down.

What about the RCBS powder check die?

Ok I’m thinking about driving a semi-truck OTR as a new job. Does anyone here reload/process brass, cast bullets, ect… while on the road? I know with powder & primers may not be good in the truck but processing 223 brass should able to be done? Same with casting then mail stuff home as I get...

55gal Trash bag unless you want it to look "good" prying eyes. I do the same as F100 and make mounts so things can go away/out of sight for off times.