Recent content by wy child

They must be getting ad advice from PETA:o

I have UC 45 witch I use as a CC on a daily basis, When i first got it I had problems with the ejector, causing jamming. After close inspection I found that the ejector had a flat surface that would slam into the base of the case and would not slide over the lip, it also put a large dent in...

shooting standard sized clay birds @400yards >with rifle or with a pistol @ 10,25 and 50 yards or 50 and 100 yards with an AR using open or red dot sights,standing and sitting.

add a table spoon of new finish car polish ( it does not have ammonia in it) I have used this in mine for about 2 years and have polished thousands of cases. as has been said you will have to clean out the primer pockets on some cases.

I have only named one of my guns and that is my rem 700 SPS rifle Because I found the name quite fitting, the was Black Mamba after a very dangerous snake.

I would go with the 45 as I have arthritis in my wrist and a 10's recoil hearts,but I can handle the 45' recoil just fine. :p

RP brass is a little thinner then say Winchester or Federal. although I have never had problem with RP brass unless it had 8-10 reloads on them. One question do you clean your brass in a liquid cleaner or add additional polish to your medium if so check to see if it contains ammonia as it...

I have to say yes, but as some of the other posters I shoot much more then if I was buying commercial cartridges. but how do you put a price on the overall improvement in your accuracy buy shooting more and the just plane fun derived from this activity + the increased knowledge derived. + the...

at least once a week weather permitting

ok here is a point that I haven't seen here yet, different case manufacturers have different wall thickness. the thicker the case the smaller the volume. I you mix manufacturers cases you will get different pressures Military brass has a thick case so does Lapua. Winchester and FC are thicker...

I have built a spread sheet that I used to keep my load data I attache my final target group for each load I have worked up Also a copy of the calculated trajectory. Here is what I have on the spread sheet Caliber 308 Mfg Rem 700P Barrel length 26" Bullet type SBT Bullet gr 165 Bullet...

very good source of information. http://gunfacts.info/:o

I have introduced untold number of people to shooting in my 71 years I tried to take at least one none shooter shooting each year. Introducing young people to guns and hunting is probably one of the most satisfying things I have done in my life. One of my most memorable experiences was a...

check out this link for the information http://www.rc-trucks.org/remington-firearms-serial-numbers.htm

I have had my Rem 700 about a year and just finished working up this load ( for my rifle only ) Notice the COL .010" back off from the lands. The bullet was a Sierra Game king and fire formed FC cases. When I can afford it I will try Lapua Cases and bullets.see attachment This is a 5 shot group.