Recent content by ZOG

"WARNING on SWFA " One retailer "warning" us about one of his competitors! This is outragious behavior and I feel the moderators and owners of this board shoould review the policies that allow someone like WildAlaska to isssue such slanderous remarks about some one who has earned and...

The only way to break the bond is with heat. It won't take too much. Start with a soldering iron, you can pin point the heat very well with that on small screws. If you need more use a small butane pin point torch, carefully put the heat only on the screws. If you are worried about...

The wildest gun laws in this state allow us to buy anyone's pre-ban AR15 except the only one made here. . . . . . . .COLT !

I just purchased an Eotech 420 Holographic sight, (Bushnell Holosight). It turns out this particular model may be made for a bow and I am mounting it on a rifle. It does not have any zeroing adjustments. When I mounted it on my rifle the cener of the red dot was off to the right a bit when...

I just purchased an Eotech 420 Holographic sight, (Bushnell Holosight). It turns out this particular model may be made for a bow and I am mounting it on a rifle. It does not have any zeroing adjustments. When I mounted it on my rifle the cener of the red dot was off to the right a bit when...

Glad to be here !

I've got 2 Mitchell M16 .22 clones and both work great. If you find an Italian made Jaeger buy it! These work good but as others have mentioned there is a lot of Mitchell crap out there, primarily made in the Philipines.

If you want to go .308 but keep the cost down check out the new DPMS 308 http://www.dpmsinc.com

I have an A2 style upper with integrated carry handle. I would like to chop off the handle and put some type of flat top rail on it. Has any one done this? What will Fit?