CMB
Member
- Joined
- Aug 8, 2020
- Messages
- 111
I guess the bottom line question is to those using the V3, how crucial is the ¼ inch window?
There is not enough room between the end of the hand guard and the muzzle device (dragon ASR) to mount the V3. One option is to mount it to the ASR blast shield but this puts it pretty far out.
If I use a rail section in the front most m-lok holes (current rail section is magpul) and the rail adapter the sensor surface sits over the ¼", very close to ⅜ of an inch. The magpul section is fairly thick. I figured I could try it this way or try to find a "low profile" section as the rail adapter is not adjustable. Another option could be to machine the rail section to remove material where the rail section meets the hand guard.
Has anyone else ran into this?
Thanks All-
There is not enough room between the end of the hand guard and the muzzle device (dragon ASR) to mount the V3. One option is to mount it to the ASR blast shield but this puts it pretty far out.
If I use a rail section in the front most m-lok holes (current rail section is magpul) and the rail adapter the sensor surface sits over the ¼", very close to ⅜ of an inch. The magpul section is fairly thick. I figured I could try it this way or try to find a "low profile" section as the rail adapter is not adjustable. Another option could be to machine the rail section to remove material where the rail section meets the hand guard.
Has anyone else ran into this?
Thanks All-