Thanks for the phone number. If it’s listed on their site, I’m not able to find it. And Support doesn’t list a phone number at all, just the contact form they say will take several weeks to respond to. I’ll try the number you gave me on Monday. Thanks again.
Thanks for the response. It’s not the measure just rising up, it’s more like the powder bar is slightly catching on something coming and going but I don’t see anything that might be doing that.
I recently had to remove a small powder slide that was increasingly hanging up. Discovered wear marks on one side that had raised a burred edge on the top left side of the slide. Lightly filed it down and made sure the corners were slightly rounded and it cured the problem. At some point perhaps in storage perhaps it had acquired a small ding that was dragging. The slides aren’t exactly hardened metal.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.