Hi Folks,
I had a squib today at the range and it jammed into the 4" barrell.
I got home, and with a wooden dowel and a dead blow hammer was able to persuade the bullet back into the case. Then I proceded to tap the cylinder into the open postion because it was stuck and removed the offending round. Now the cylinder release lever will not go fully aft and lock the cylinder in place and therefore the hammer will not cock. I can post pics if needed. I removed the side cover and exposed the trigger guts and nothing seems out of place or bent. Any thoughts or do I need to see a smithy?
I had a squib today at the range and it jammed into the 4" barrell.
I got home, and with a wooden dowel and a dead blow hammer was able to persuade the bullet back into the case. Then I proceded to tap the cylinder into the open postion because it was stuck and removed the offending round. Now the cylinder release lever will not go fully aft and lock the cylinder in place and therefore the hammer will not cock. I can post pics if needed. I removed the side cover and exposed the trigger guts and nothing seems out of place or bent. Any thoughts or do I need to see a smithy?