Freelance Tax Collector
Member
- Joined
- Oct 13, 2005
- Messages
- 222
Hi all, this is my first post for quite some time, and unfortunately I have a problem.
I was aware of this problem before I purchased. I thought I had fixed this. The cylinder keeps falling out after firing. I disassembled the side plate but the crane, cylinder retaining pin, spring, and screw didn't look like they were damaged. Still though, when I shoot or even push into the cylinder real hard, it clicks out of place and the whole crane can slide out of the frame. I'm thinking that the crane retaining pin pin just isn't doing the job, but as I said, there is no damage to any of the relevant components. With the cylinder locked into place it still cycles just fine, lines up with the barrel and doesn't bind or anything like that. Tightening that screw too much causes the cylinder to bind, but the less tight the screw is, the easier the cylinder is to push out. Any pointers?
I was aware of this problem before I purchased. I thought I had fixed this. The cylinder keeps falling out after firing. I disassembled the side plate but the crane, cylinder retaining pin, spring, and screw didn't look like they were damaged. Still though, when I shoot or even push into the cylinder real hard, it clicks out of place and the whole crane can slide out of the frame. I'm thinking that the crane retaining pin pin just isn't doing the job, but as I said, there is no damage to any of the relevant components. With the cylinder locked into place it still cycles just fine, lines up with the barrel and doesn't bind or anything like that. Tightening that screw too much causes the cylinder to bind, but the less tight the screw is, the easier the cylinder is to push out. Any pointers?