Marquart Neck Turning Tool

Status
Not open for further replies.
R

RTC

Member
Joined
Dec 24, 2005
Messages
30
Location
NC
OK, I now have a Marquart neck turning tool with pilots for 22 caliber, 24 caliber, and 25 caliber. Does anyone know where I can get additional pilots for 7mm caliber and 30 caliber? Or does anyone know what manufacturer replaced Marquart? Thanks up front for any answers!:)
 
No problem, checking the shank on my Marquart pilots, they measure .342". The shank on my K&M pilots measure .3415", meaning they are essentially interchangeable and easy to get. If you can afford the difference in price, I recommend buying the carbide pilots, especially if you do a lot of turning with a power drive. Marquart was a one man operation and noone took over his small operation after his death. His neck turning tools, like all his other work, were top quality.
Offfhand
 
Marquart Neck Turning

Thanks for the reply. I had gotten to the same answer by email to Precision Reloading and sending some measurements back and forth. I'm going to order two K&M pilots in 7mm and 30 calibers. I'll repost how they work when I get them.

:)
 
K&M builds quality tools. Ditto on the carbide. I like the flutes; donuts are a thing of the past.
 
Status
Not open for further replies.

Similar threads

C
  • Locked
7x57 Ackley Improved Pet Loads?
Replies
5
Views
5K
cal30_sniper
C
C
  • Locked
Neck turning pilots
Replies
18
Views
2K
ironworkerwill
ironworkerwill
M
  • Locked
K & M Neck Turners and Expanders
Replies
3
Views
472
Offfhand
Offfhand
A
  • Locked
Neck Turning Tools
Replies
12
Views
1K
taliv
T
G
  • Locked
Questions about neck turning, minor issue
Replies
24
Views
1K
gamestalker
G
Back
Top