Hardtarget
Member
I have a good amount of brass. I started checking it and measured several only to find lots if different lengths. Some are shorter than the "trim to" length.Should I trim the long cases and then sort the rest by length? That way, I could seat the bullet and crimp each group and not have some seated too deep or too shallow. Should I reduce powder charge in the short cases to avoid high pressure?
We will be short rang plinking so critical accuracy concerns are not part of my worries. I just want safe, reliable ammo. Those old tin cans are not dangerous.
Thanks!
Mark
We will be short rang plinking so critical accuracy concerns are not part of my worries. I just want safe, reliable ammo. Those old tin cans are not dangerous.
Thanks!
Mark