nuts. no idea what happened before, and hard to tell who the aggressor really is/was. seems like they just want to act tough, but they both seem...
great minds think alike
I like the PCC for shooting steel targets at closer ranges, 25-50 yards. A .22 LR is fun too, but 9mm brings it up a notch. The steel can't take...
depending on how many you are doing. once the trimmer is set up, I just trim the batch to the trim to length. measure after they are sized.
I have a Ruger PCC 9mm and a few .22 Rifles and handguns. The handguns have .22 Mag cylinders, but I've never really considered a .22 Mag rifle,...
A pump .357 to me would be ideal, if it worked really well and was not so expensive. Nothing against lever guns, but shooting a pump is my...
believe it or not, I've gone through just about everything in this photo in the last couple months. first real house clean out since the 10 years...
you'll get all kinds of opinions. the cartridge you are talking about is a solid pistol round. if you spend any time thinking about one pistol...
Stack-On SORB-48 Adjustable Height Pro Reloading Bench – Black - USA-reloads I was looking at this as a possible set up. I have two presses,...
had an issue like that once, not gunbroker, but I just rejected the inspection outright at my FFL and said send it back where it came from, cut my...
if in the original box, and no apparent corrosion or damage, dents etc. my understanding is that is likely to be as good as current factory ammo....
I have a couple boxes of 303 British brass that, since I don't own anything that shoots 303 British and don't plan to, is for the taking in...
moving closer
knowing what you're shooting at and why makes sense. to me, I'll shoot center of mass, if they don't stop or go down right away I'll shoot either...
categorizing and reorganizing, putting dies I probably am not going to use this season out of my area, as with extra brass ... setting up a better...
Shoot a Walther in .32 ACP, it is lively - and fun, but not as much pop to is as a .38 ACP. I don't have one, but have a CZ-70 similar type, that...
I'll store it all, cleaned and de primed. I'll probably go with the polishing product to give it a little protection and throw dessicant packs in...
me too ... lol
not sure. I just load .223 Remington with .223 Remington dies. 5.56 brass is the same, just a touch thicker, but - if you are learning to load...
better just make a long term strategy to get one of each
Separate names with a comma.
