I noticed a similar problem with 9mm one time. The bullets would deform up into the seating die causing erratic OALs. I made a totally flat...
I load a fair bit of 380. Never seen a split. I have seen a few in 9mm though. No real rhyme or reason to it. I figure either the case had been...
I use one of their kits in a Walther PPS m2. It runs like it should. Never a failure to feed or any other undesirable event. An occasional failure...
Here's a 9mm PowerPistol shot I recently captured indoors.... Outside it's hardly noticable. [ATTACH]
A number of years ago I bought some Hornady .380 auto dies that came with a roll crimp. And no taper crimp die. I was pretty disappointed. IIRC,...
I've used some Buffalo Bore ammo. Its good stuff. The couple loads I have ran through a chrono matched their advertised numbers very closely.
I am currently experimenting with a 200gr XTP load at 1.350". So far it shoots great out of my Blackhawk with the little bit of working up I have...
I dont feel like that is gonna help much with a simple taper crimp.
Already on it it. I have a 200gr XTP load at 1.350" in the works. Once I get the powder charge up where I want it then I gotta start looking at...
I recently picked up the 10mm/40sw Blackhawk. Kind of an impulse buy I suppose. I like the 10mm round, but as a reloader, I got sick of trying...
Last night I pulled all the bullets out of 100rds of factory 357sig that my brother in law gave me. 125gr FMJ. Neither of us shoot that cartridge....
I've used SRP's in 357 mag. No issues.
I mainly use it in the low pressure "special" cartridges. Works great there. The powder is not bothered by excess air space often left in those...
I had one a few years ago. It produced a sharp, stinging recoil that the wife and I did not appreciate. Just the nature of straight blowback I...
There are a surprising number of people out there that believe simply dropping the mag unloads the gun. Which is why, I am sure, the mag...
20cv/g10 Griptilian. Walked in looking to buy the CrookedRiver, but changed my mind. Better ergos, better steel, better price. Maybe next time.
Yeah.... I had to dig pretty deep into the interwebs to find recommendations for starting charges. Not necessarily published data either....
I used to use a lot of PowerPistol. It works wonderfully for full power jacketed loads. Later on though I starting wanting more economical, less...
EDC... [ATTACH]
I recently switched from Glock to Walther. The PPS m2 fits my hands much better. It stays put through a whole mag even with the flush base plate,...
Separate names with a comma.
