Got it off.... Lessons learned: The Midway "AR Stoner" wrench barrel nut teeth are a major POS, do not buy. They are not machined in, I think...
Update... got the barrel stripped pretty easily, and got the front sight post cut down and blued with Perma Blue. If you look at it you can tell...
www.uspsa.org www.idpa.com Both will have club finder functions on the website to show where all the local clubs for any given area now. Also,...
All the components I'm planning to use are in the mail. I'm planning to stick with the stock barrel. It appears that an identical Colt barrel...
Its a BCM mlok rail. Thanks
Looks good! I guess I'll shoot it. First with the upper in 100% stock config just to make sure everything works out of the box, then will likely...
I do have the box and should have everything else too. I have other SBRs so I could easily just buy an upper and shoot it on this lower or a...
I don't much either; this is a pretty rare exception. I also have an unfired 6920 and a couple pistols, but virtually all of them get sold or...
Thanks C-grunt... so if I cut down the FSB to put a rail on this I'm not going to regret it? I guess push comes to shove I could get a second...
Thanks dcloco, I did see those, however: -The 1550$ one is showing on backorder, and has no real pictures so I'm assuming that is a current...
I've had this gun new and unfired in the safe for years. It is a factory complete SBR. It is marked "M4LE/COLTS LAW ENFORCEMENT" on the left and...
There was one, probably 4" plate at about 60 yards, that was the closest rifle target. 2-10x would have worked fine I think, but also I thought 8x...
Not sure how it would be staked, but a spring detent in the end of the rod should eliminate any potential issues no matter what. I'm guessing the...
Thanks for the info guys, and Cemetery for the specific info and offer! I do appreciate it. I think I'll just go the mega-pack route or get a...
Midway/Brownells look to just have complete kits. Actually this looks interesting: https://www.midwayusa.com/product/1021314696?pid=723508...
Does anyone know where, or if, I can get some extra of the microscopic E clips that retain the rod for the dust cover in the upper receiver? Got...
Just throwing this out there in case there are others within range who would have liked this match; it is the first match of its kind they have...
1911 to me is tiny, it is very much bigger than that. Probably a little bigger than a g17.
Assuming you are talking about the full size metal frame witness, yes, they are all the same size. The smaller cartridge mags (9mm, .40) have a...
I shoot lefty and have owned probably a dozen or more ARs, in multiple calibers, and shot a wide variety of factory and handloads. Can't recall...
Separate names with a comma.
