Years ago (when SERPA holsters were still fawned over) one made for a Beretta M9/92 could fit slide and barrel of the shorter 92. Centurion I...
No hang fires in the M16 family for me. Never fired the M60. Part of my enlistment was spent on a 240 gun team so learning how to do a blind sweep...
Phillips head screwdriver #2 to get the rubber pad off. Long shank flat head screwdriver to tighten the stock bolt. I wouldn't worry about it...
DIY Anodizing can be done if you follow the steps and get the right materials. Alumnahyde II is a good option as well and much easier than anodizing.
Not exactly sure whose slide it is. They claim to make all parts in house but a lot of companies make that claim and don't. This slide was part of...
My nearest outdoor wildlife range (hour away) uses a string of clothesline strung across all the lanes at set distance. I think they are 15, 25,...
This factory cut notch is not as deep but a bit longer than the one you made.
I have one 1911 with the notch and one without. And I haven't fired either enough to notice a difference. Even if I did, there is enough...
You have to ask to take political signs. And only at the end of the election cycle, plus whatever local laws say about appropriate clean up times...
More than that. Almost double. Magazine capacities in 12ga shotguns are advertised with 2 3/4" shells. So take a Mossberg 500 with a factory...
Something something fools and money are easily parted.
Some stock slides come with that notch. Although yours looks deeper than all of them I have seen. May take a picture of my mostly stock 1911 build...
I have about equal number of both. But I lean more towards handguns. I can recall the exact dates I last shot all my handguns, not the same for my...
I would like to give Daniel the benefit of the doubt. When you are talking to Congress, every word should be carefully thought out. If Daniel had...
The reason we were told was the cynical, ammo and weapons are made by the lowest bidder. I believe that combined with the fact that the M249 and...
Reading so far it feels like I have a lot more needs on my 1911s than other people. In order of precedence: good sights and good trigger. I prefer...
Not worth a lick of good. Because this carve out follows every decision about TSA. I carry a key fob that stacks the keys instead of dangling....
Half dozen over the million plus rounds I have fired over the years. Some of those were on belt fed weapons where hang fires are common enough to...
There were a lot of people on this very board that said it wasn't going to pass the House. It did. Same folks are saying it won't pass the Senate....
Lack of demand is one reason. Savage may just be jumping the gun on the House's vote to ban assault weapons too. If that bill gets much farther, I...
Separate names with a comma.